42 lines
2.6 KiB
Markdown
42 lines
2.6 KiB
Markdown
# Tuning the printer
|
|
1. **PID_CALIBRATE HEATER=heater_bed TARGET=100**
|
|
1. This will take ~10min
|
|
2. Once this is done, use **SAVE_CONFIG**
|
|
2. Run **M106 S64** command <- this will turn on the part cooling fan at 25%
|
|
3. Run **PID_CALIBRATE HEATER=extruder TARGET=245** command
|
|
1. Once this is done, use **SAVE_CONFIG**
|
|
4. Next up take a ruler and try to get gantry as even as possible on both sides.
|
|
1. Make sure the nozzle will clear the bed
|
|
2. Run **G28** command
|
|
3. Press QGL to start automatic leveling
|
|
1. The probe will measure distance in all four corners and adjust is each corner automatically until all corners are adjusted. It will try up to five times before giving up.
|
|
2. Tolerance allowed is ***0.00750***, if you did your assembly correctly, it should be no problem to beat.
|
|
5. Extruder
|
|
1. Add bowden to the the toolhead
|
|
2. Try to extrude filament, configuration is already tuned for you
|
|
6. Z-Endstop calibration
|
|
1. Once the chamber has heated up (set extruder to 240, heat bed to 100)
|
|
2. Add a sheet of paper between the bed and toolhead
|
|
3. Run **Z_ENDSTOP_CALIBRATE** command
|
|
1. Then run **TESTZ Z=-1** command until the nozzle is close to the paper
|
|
2. If you go too far, run **TESTZ Z=1** command
|
|
3. Once you are close, switch to **TESTZ Z=-0.1** command
|
|
4. Do this until you feel a drag on the paper when moving it
|
|
5. Remove the paper
|
|
6. Beacuse we did this hot, we need to run one more **TESTZ Z=-0.1** command
|
|
7. Run **ACCEPT** command
|
|
8. Run **SAVE_CONFIG** command
|
|
9. The nozzle bed offset is done for now.
|
|
7. Tighten ***all*** the screws while cabin is still hot.
|
|
|
|
Thats it for tuning. You should be now ready for your first print. If you had any issues along the way, you can take a look at [very detailed tuning guide](https://github.com/AndrewEllis93/Print-Tuning-Guide) by AndrewEllis93.
|
|
|
|
Don't have an idea what to print? Try printing a [cube](https://www.thingiverse.com/thing:5429894) and filming it for [serial request](https://www.reddit.com/r/voroncorexy/). Please read about the process in [this serial request information questions reddit thread](https://www.reddit.com/r/voroncorexy/comments/r4ggml/serial_request_information_questions/).
|
|
|
|
> **PS:** For configuring MainsailOS from SSH, enter **SUDO raspi-config**. From there you can join your device to WiFi should you choose to do so and change local network domain name.
|
|
|
|
---
|
|
### Back: [Manuals](../Readme.md)
|
|
|
|
# Sources:
|
|
[Youtube: Voron 2.4 Step By Step Part 13 Tuning, SuperSlicer and First Print](https://youtu.be/1wBi1mXVVEQ) |