38 lines
1.7 KiB
Markdown
38 lines
1.7 KiB
Markdown
# Tuning the printer
|
|
1. PID_CALIBRATE HEATER=heater_bed TARGET=100
|
|
1. This will take ~10min
|
|
2. Once this is done, use SAVE_CONFIG
|
|
2. Enter M106 S64 <- this will turn on the part cooling fan at 25%
|
|
3. Enter PID_CALIBRATE HEATER=extruder TARGET=245
|
|
1. Once this is done, use SAVE_CONFIG
|
|
4. Next up take a ruler and try to get gantry as even as possible on both sides.
|
|
1. Make sure the nozzle will clear the bed
|
|
2. G28
|
|
3. Press QGL to start automatic leveling
|
|
1. The probe will measure distance in all four corners and adjust is each corner automatically until all corners are adjusted. It will try up to five times before giving up.
|
|
2. Tolerance allowed is 0.00750, if you did your assembly correctly, it should be no problem to beat.
|
|
5. Extruder
|
|
1. Add bowden to the the toolhead
|
|
2. Try to extrude filament, configuration is already tuned for you
|
|
6. Z-Endstop calibration
|
|
1. Once the chamber has heated up (set extruder to 240, heat bed to 100)
|
|
2. Add a sheet of paper between the bed and toolhead
|
|
3. Run Z_ENDSTOP_CALIBRATE
|
|
1. Then run TESTZ Z=-1 untill the nozzle is close to the paper
|
|
2. If you go too far, run a TESTZ Z=1
|
|
3. Once you are close, switch to TESTZ Z=-0.1
|
|
4. Do this until you feel a drag on the paper when moving it
|
|
5. Remove the paper
|
|
6. Beacuse we did this hot, we need to do one more TESTZ Z=-0.1
|
|
7. ACCEPT
|
|
8. SAVE_CONFIG
|
|
9. The nozzle bed offset is done for now.
|
|
|
|
|
|
For configuring MainsailOS from SSH, ener SUDO raspi-config. From there you can join your device to WiFi should you choose to do so.
|
|
|
|
---
|
|
### Back: [Manuals](../Readme.md)
|
|
|
|
# Sources:
|
|
[Youtube: Voron 2.4 Step By Step Part 13 Tuning, SuperSlicer and First Print](https://youtu.be/1wBi1mXVVEQ) |